12/13/2022 0 Comments John deere gator clutch cleaningI have posted a few inquiries on the net. The spider is really expensive!īTW, The secondary clutch sliders are available for snowmobiles and are identical. I wish Deere sold just the rollers as they used to. Hardened steel would be best for sure like the drill guides others have talked about. Not sure how long it will last but good for now. The ID fit nicely on the pin and I put a little grease on the pins. Easy to make and install and works great. So I built a set out of a piece of steel rod that was in my shop that was about the right OD and ID. All three rollers worn through to shaft below. Clutch was engaging OK, but was not disengaging reliably. Everything else in the primary looks great-moveable sheeve doesn't wobble, ramp weights are smooth, plastic bushes good. I too, am looking for a set of rollers for our old diesel 6x4. One of mine is worn right through to the shaft!. Gatoraider, do you still sell the rollers for the primary clutch on the 4x2? Instructions for removing and replacing the spider and roller assembly can be found in the post at the referenced link, below. ĭeerfield or Sanford, wherever the weather's nicer I need a set of these rollers please contact me. When I reinstall this clutch or a new one, how many foot pounds of torque should I use to seat clutch on engine?. More clutch questions, my sheaves are polished to a glass smooth finish, should I run some scotch-bright over them to break the glaze or should they be that smooth? I am going to replace the belt as it is the original 98 belt with around 600 hours on it. Sir Gator, thanks for the info, I will give it a try. If you can hold the spider, you can turn a large pipe wrench on edge and put it down over the spider on one leg and try to unscrew it that way. The tool holds the sheave and spins the spider. I have roller sets for 60.00 plus shipping. The rollers are available only with the spider assembly from Deere. You need a puller to get the clutch off and a special spanner wrench to unscrew the spider inside. Hello, I would like to rebuild my drive clutch (engine mounted), I have flat rollers and need to replace them, Can I take apart the clutch to do the job, do I need to fabricate new rollers or are they available, any help would be appreciated, thx in advance.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
December 2022
Categories |